Werbung
60
en | Changing the Configuration via a Web Browser
8.
9.
10. In the Network Interface pane, click LAN 0, and then click Static.
11. In the IP Address box, type the new IP address for LAN 0.
12. In the Subnet Mask box, type the new subnet mask for LAN 0.
13. In the Network Interface pane, click LAN 1, and then click Static.
14. In the IP Address box, type the new IP address for LAN 1.
15. In the Subnet Mask box, type the new subnet mask for LAN 1.
16. Click Apply to open a dialog box where you accept the changes.
17. Click OK.
NOTICE!
For security reasons we also recommend changing the passwords of the access levels for
Configuration and Maintenance. In the Configuration Parameters pane, click the Password
tab, and then change the passwords accordingly.
The password for the access level Information is 1234 (default) and cannot be changed.
10.2
Guidelines for Setting up a RAID
To change the factory default settings and the optional settings, use the following procedure.
To create a logical drive:
1.
2.
3.
4.
5.
6.
7.
8.
9.
To add partitions:
1.
2.
3.
4.
5.
6.
7.
8.
9.
NOTICE!
For Bosch DVRs it is not necessary to create Logical Volumes.
F.01U.027.801 | V5 | 2010.06
In the navigation tree, click Configuration, and then click Configuration Parameters
In the Configuration Parameters pane, click the Communication tab.
Click the Windows Start button, point to All Programs, point to Bosch, and then click
Bosch RAIDWatch. The applications opens log on dialog box.
In the navigation tree, click Configuration, and then click Create Logical Drive.
Click the physical drives from the Front View pane, that are used in the Logical Drive. The
Selected Members pane displays the disk drives slot IDs and sizes.
In the RAID Level list, click a raid level.
In the Stripe Size list, click a stripe size. We recommend using a stripe size of 16k.
In the Initialization list, click On-line if the storage should be available immediately for
the host. Or, click Off-line if the storage should be available after initialization is finished.
In the Write Policy list, click Default.
Click OK. The application opens a dialog box where you accept the changes.
Click OK to create a logical drive.
In the navigation tree, click Existing Logical Drive.
In the Logical Drives pane, select the logical drive you want to partition.
Right-click the selected logical drive, and then click Edit Partition. The application opens
the Edit Partition dialog box.
Right-click the partition bar, and then click Add Partition. The application opens the
Partition Size dialog box.
Type the desired capacity, and then click OK. Some DVRs only support a maximum
capacity of 2 TB.
Close the Edit Partition dialog box.
In the Write Policy list, click Default.
In the Password box, type the password if needed.
Click Apply.
Quick Installation Guide
RAID Subsystem DVA-12T
Bosch Sicherheitssysteme GmbH
Werbung
Kapitel
