To Fill And Refi Ll The Spray - Petsafe PBC17-14135 Gebrauchsanweisung

ON (l)/OFF (O)
• To activate the Bark Control Collar, slide the ON (l)/
OFF (O) switch to the ON (l) position.
• To turn the Bark Control Collar OFF (O), slide the switch
to the OFF (O) position.
• Before every use, it is recommended to test the Bark
Control Collar. Holding it approximately 9 centimeters
from your face, point the Spray Nozzle away from you
and blow into the Microphone.
STEP 3
To Fill and Refi ll the Spray
Important: Always make sure that you are not mistakenly
trying to fi ll the reservoir through the Microphone opening.
This would damage the Bark Control Collar.
• Remove the Bark Control Collar from your dog and turn
it OFF (O).
• Set the Bark Control Collar on a fl at surface with the Refi ll
Port (deepest cavity) turned upwards.
• Hold the Spray Can upright and fi rmly press the nozzle
down into the Refi ll Port. Hold down fi rmly for 10 seconds
and release. Press down for another 10 seconds, then
release again. You cannot overfi ll the Bark Control Collar.
Note: If spray leaks out, you may need to press harder to complete the seal.
• Turn the Bark Control Collar ON (l).
Note: Never fi ll the Bark Control Collar while your dog is wearing it because it may
damage the Refi ll Port. Never fi ll the Bark Control Collar with any substance other than the
one provided by the manufacturer. PetSafe
Using another substance, as well as opening the Bark Control Collar, will void the
manufacturer's warranty.
8
® spray refi lls are available at www.petsafe.net.
www.petsafe.net