Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Never carry the device with the finger on the
■
trigger. If the attachment sleeve is pressed
inadvertently, a pin can be fired and cause
serious injuries.
Always discharge the device before you take
■
a break, at the end of the working day, before
trouble shooting and maintenance works and
before changing wear and tear parts.
Symbols in this instruction
manual
Danger
For an immediate threat of danger
which causes serious injuries or death.
Warning
For a possibly dangerous situation
which may cause serious injuries or
death.
Caution
For a possibly dangerous situation which may cause
minor injuries or damage to property.
Proper use
This device is intended to be used for firing pins
(fasteners) into concrete, full block calcium silicate,
full bricks and steel using the original Würth system
parts.
Any other use is considered improper use.
The user is liable for damage resulting
from improper use.
Safety instructions
Warn others of detonation sounds in the vi-
■
cinity of the mounting base which occur when
working with the device.
Unexploded ordnance, or cartridges which
■
are no longer required but operational must
be collected and brought to a suitable col-
lecting point.
Only use genuine Würth accessories
■
and spare parts.
Overview (fig.
1 Magazine kit
2 Single shot kit (option)
3 Housing
4 Actuator
5 Magazine strip
6 Unlocking mechanism for magazine feed
7 Power adjustment
8 Nail / pin
9 Cartridge strip
10 Piston spring
11 Damping ring
12 Piston
13 Piston sleeve
Item
Pin guide
Dimensions
(overall length)
Weight
Driving energy
Disc cartridge
Recommended maximum
firing power
Components
I
IV)
Technical data
0864 21
Ø 8 mm
490 mm
(525 mm incl. magazine)
3,7 kg
(3.99 kg incl. magazine)
380 J
Calibre 6.8 / 11 mm
in strips of 10
900/h
13
Werbung
Inhaltsverzeichnis
Fehlerbehebung
