Velleman HAA85 Bedienungsanleitung Seite 6

2) PROGRAMMING -- Put the required data above into the keypad
0 0 0 0
0 3 2 8
1 8 3 2
2 6 8 5
4 0 5 #
5 1 #
7 0 #
*
Note: In case of wrong entry during programming, cancel it with key #, or wait 10 seconds, then re-enter.
7. Use the Keypad – Taking the Stored Data Above as Reference
1) To command relay output 1, enter the user code 1 and validate via #.
8 3 2 1
2) To command relay output 2, enter the user code 2 and validate via #.
6 8 5 4
3) The Personal Master Code is also the SUPER USER CODE for relay output 1 and 2. The owner can use only
ONE code to operate the two outputs. To command outputs 1 and 2, enter the Personal Master Code into the
keypad and validate via # and the corresponding output number.
3 2 8 9
3 2 8 9
4) The DURESS CODE does not need to be programmed. The keypad determines it automatically by increasing the
first digit of the User Code 1 by TWO units.
e.g. If we have the User Code 1 is 1234, then the keypad will determine the Duress Code as 3234.
In the above programming example, we have made User Code 1 as 8321, the Duress Code has been determined
as 0321 automatically by the keypad. To command the DURESS OUTPUT, enter the Duress Code and validate
via #.
0 3 2 1
The Duress Code has a double action; it controls the relay output 1 at the same time as the User Code and
activates the Duress Output. Only the composition of the User Code 1 can deactivate the Duress Output. The
Duress Code can always activate and deactivate the relay output 1, but can not deactivate the Duress Output.
HAA85
Enter in programming mode by the factory set master code.
*
3289 has been stored as the new Personal Master code &
9 #
Super User code.
8321 has been stored as User Code 1 & Duress Code.
1 #
6854 has been stored as User Code 2.
4 #
Relay output 1 has been set in Momentary Mode, 5 seconds
Relay output 2 has been set in Start/stop Mode without
accelerated code.
The keypad has been set to lock during 30 seconds after 10
successive false codes.
Programming is finished. All the required data above have
been stored.
Relay output 1 activates for 5 seconds.
#
Relay output 2 starts.
#
Relay output 1 activates for 5 seconds.
# 1
Relay output 2 starts.
# 2
Duress output activates, and relay output 1 activates for 5
#
seconds.
6 VELLEMAN