Layout Of The Instrument Panel - REMEHA Gas 210 ECO Bedienungsanleitung

1. air supply
2. flue gas outlet
3. combustion test point (O
4. sealed air box
5. differential air pressure switch (LD2)
6. IMS gas-air ratio control
7. air supply fan
8. pre-mix, fibre faced burner
9. combined ignition/ionisation probe
10. sight glass
11. gas valve multiblock (with governor)
12. cast aluminium, sectional heat exchanger
13. temperature sensor - flow
14. temperature sensor - return
15. temperature sensor - heat exchanger
16. temperature sensor - flue gas
17. drain pan (condensate)
18. condensate connection
19. heat exchanger inspection hatch
20. instrument panel
21. facility for incorporating a rematic
compensator (optional)
22. boiler setting keys

LAYOUT OF THE INSTRUMENT PANEL

fig. 02 Instrument panel
The Remeha Gas 210 ECO boiler is supplied with an
instrument panel. This instrument panel is provided with
an intelligent, advanced boiler control ('abc
keys, different menus can be accessed, various values
can be read and settings made. The instrument panel
consists of the following components:
1. On/off switch.
2. PC-connection.
3. Facility for incorporating a rematic
compensator.
A. Code-display, indication of operating, setting,
read-out, shut-off, test and failure codes.
t-display, indication of temperatures, settings
B.
and shut-off and lock-out codes.
/CO )
2 2
weather
®
'). Using the
®
weather
®
23. read-out display and reset key
24. on/off switch
25. gas connection
26. flow connection
27. return connection (standard)
28. drain cock and optional second return connection
(when fitted) or optional low level return connection
instead of standard return connection
29. connection for optional thermostat pocket (for use
with external sequence control).
An intelligent, advanced boiler control* ('abc
ously monitors the boiler conditions, varying the heat
output to suit the system load. The control is able to
react to external "negative" influences in the rest of the
system (flow rates, air / gas supply problems) maintain-
ing boiler output for as long as possible without resorting
to a lock out condition. At worst the boiler will reduce
its output and/or shut down (shut off mode) awaiting
the "negative" conditions to return to normal before
re-starting.
The 'abc ' control cannot override the standard flame
®
safety controls.
C. Reset-key, to reset the boiler after a lockout.
m-key, key to select the required mode
D.
(mode-key).
s-key, key to select the required program
E.
within the selected mode (step-key).
e-key, key to save the settings (store-key).
F.
G. [+]-key, to select a higher setting.
H. [-]-key, to select a lower setting / switch
function: manual override (hand/auto).
9
') continu-
®