Dometic CAM30C Installationsanleitung Seite 12

Mounting the camera
If you would like to attach the bottom camera holder with threaded screws fitted
through the construction
A
NOTICE!
Ensure that nuts cannot be pulled through the body shell when they are tightened.
Use larger washers or metal plates if necessary.
➤ Drill Ø 5.5 mm holes at the points you have just marked.
➤ Deburr all drill holes and apply rust-protection.
➤ Place the insulating plate (fig. 3 5, page 2) where the bottom camera holder is to be fitted.
The insulation plate serves as a seal and protects the paint.
➤ Screw the camera holder on with the M5 x 25 mm threaded screws (fig. 7 A, page 4).
Depending on the thickness of the construction, you may require longer threaded screws.
Fastening the camera
➤ Push the camera into the bottom camera holder.
I
NOTE
Remember that the LDR sensor (fig. 4 5, page 3) must face downwards so that the
picture is correctly shown on the monitor.
➤ Fasten the camera loosely using the top camera holder and the two M3 x 12 mm screws
(fig. 7 B, page 4).
I
NOTE
Do not tighten the two screws until you have aligned the camera (see chapter "Check-
ing the function and setting the camera" on page 13).
To do this you must first install and connect a monitor (see the connection diagram
fig. 9, page 4).
Creating a through-hole for the camera connection cable
I
NOTE
If possible, use available openings – such as ventilation grilles – to feed the connection
cables through. If there are no existing openings, you must drill a hole with a 13 mm
diameter. Check beforehand that there is sufficient room for the drill head to come out
on the other side.
➤ Drill a hole of Ø 13 mm near the camera.
➤ Deburr all drill holes that have been made in the sheet metal and apply rust-protection.
➤ Seal the duct with the sleeve (fig. 4 3, page 3).
12
PerfectView
EN