Bresser TemeoTrend Sunny 70-00001 Bedienungsanleitung Seite 15

these values a weather forecast for the next 6
hours is calculated.
Current weather
Sunny
Partly cloudy
Cloudy
Rainy
Temperature trend
Rising
Steady
Falling
Main unit signal receiving check
The transmission range is about 30 meters from
the remote station to the main unit (in open area).
The main unit should receive the temperature/
humidity information from the transmitter within 3
minutes after set-up.
Should the main unit not receive information from
transmitter within 3 minutes after setting up, please
check following steps:
1. Press and hold CHANNEL button for 2-3 sec to
re-start receiving from the transmitter; the data
will normally be received within 3 minutes.
2. If the first step does not yield a desirable solution,
please remove the batteries and re-install them
(hardware reset).
At the same time, please make sure the following:
1. The main unit as well the as transmitter should
be at least 5~6.5 feet (1.5~2 meters) away
from any interfering sources, such as computer
monitors or TV sets.
2. The main unit should not stand close to metal
window frames.
3. Please do not using other electrical products,
such as headphones or speakers, operating on
the same signal frequency (433.92 MHz).
4. Electrical devices operating on the same signal
frequency may also cause interference. This
can include devices used in the neighborhood
as well.
Main unit channel setting
1. The main unit can be connected with a maximum
of up to 3 transmitters.
2. Press the CHANNEL button to switch between
the displays of each channel. The main unit will
display the information of the corresponding
transmitter.
Automatic time setting
1. After the batteries are installed. The clock will
automatically search for the radio signal. It takes
about 3-5 minutes to finish this process.
2. If the radio signal is received, the date and time
will be set automatically and the radio control signal
icon turns on.
If the clock fails to receive the time signal, go ahead
with the following steps:
1. Press and hold the UP button for 2 seconds to
re-initialize RC signal receiving.
DE
GB
FR
IT
ES
15