Mounting Of The Enclosed Etched Labels - roco BR 03.10 DR Handbuch

Please note! To achieve proper mounting
of the enclosed etched labels will you
please follow these instructions:
As delivered the etched label surface is com-
pletely covered with paint. To make the metal
numbers and letters visible the paint must be
removed from the actual letter and numeral
surfaces: this is done as follows:
1. Before removing the labels from the etched frame place them with
their backs on a firm and completely level surface.
2. Remove the paint from the surface of the characters carefully either
with the ROCO rubber (art. no. 10002) a sharp knife having a straight
edge or similar
object (e.g. single-edge razor blade). Take care that while doing this
the paint surface between the characters is not damaged.
3. If the result is not satisfactory it is recommended that the remaining
paint is removed with a suitable paint remover. Thoroughly dry the labels and then
reapply fresh paint. Repeat the removal of the paint from the surface of the characters after
the new paint is completely dry.
4. Carefully extract the different labels from their etching frames and remove any remaining
burrs.
5. Attach the etched labels with very small amounts of adhesive on top of the printed signs on
the vehicle.
R b d G r e i f
B w S t r a I s
Cement
8072183920.indd 27
Working with etched Labels
R b d G r e i f
B w S t r a I s
R b d G r e i R b d G r e i
B w S t r a I s B w S t r a I s
06.09.2017 13:47:56
27
27