Cleaning - Routine - WALTHER PILOT PILOT WA XV Betriebsanleitung

1. Dismantle the spray gun (see 5.5 Retooling the Spray Gun).
2. Use a soft brush together with a compatible cleaning solution to clean the air cap
and nozzle.
3. Use a suitable cloth with a compatible cleaning solution to clean the gun body and
all remaining parts.
4. Apply a thin film of the appropriate grease type/grade to the:
• sealing collar of the piston
• O-ring of the piston
• material control needle
• needle spring
• inside of the gun body
Make sure to use a non-acidic, non-resinogenic grease type/ grade and apply same
with a soft brush. Assemble the spray gun in reverse order.
6.3

Cleaning - Routine

The spray gun need not necessarily be dismantled for cleaning if and when the
spraying medium is changed in regular intervals or upon termination of work (depen-
ding, of course, an the material used).
Notice
lt is recommended practice to clean and lubricate the spray gun frequently in accor-
dance with Chapter 6.2 Cleaning - Complete, as this will greatly help towards ensuring
a Jong service life and functional reliability.
The following requirements must be met before the routine cleaning work can be per-
formed:
• the material tank must be clean and then filled with a compatible cleaning solution.
• cleaning solution should neuer be sprayed - yet the material pressure must be avai-
lable at the gun.
The spraying system must be in Operation if a spray gun is to be cleaned.
1. Take the spray gun into Operation (see 5.2 Starting / Stopping Requirements).
2. Do not stop the spray gun until clear cleaning solution emerges from the nozzle.
only WA XV needle-pull / WA XV -ND
The material Input can be released by hand so that the
complete spraying system must not be taken into ope-
ration.
1. Pull the disk
2. Do not let go of the disk
All pressures should now be removed from the com-
plete spraying system - which should be left in this
condition until it is taken into operation again.
12
at the end of the spray gun back.
The material inlet is now open and both the material
duct and the material needle will be washed clean.
until clear cleaning solu-
tion emerges from the nozzle.
7 Repairs / Replacements
Warning
Prior to any repairs/replacements: Make sure that the spray gun is in unpressurised
condition, i.e. all air and material inputs must be shut off - if not, imminent Risk of Injury.
7.1 Replacement of defective Needle Seal Packings
1. Remove all pressures from the gun -see
2. Pull the white protective cover
3. Unscrew the hex. nut
4. Pull the "USIT" ring
5. Pull the gun front attachment
6. Remove the gasket
7. Unscrew the packing seal
8. Remove the compression spring
9. Remove the needle seal packing
10. Lubricate the new needle seal packing with a non-acidic, non-resinogenic
grease type / grade.
11. Install the new needle seal packing in the gun body.
Installation of the remaining parts in reverse order.
Caution
Never reinstall a used needle seal packing as, otherwise, the functional sealing
reliability of the spray gun will suffer.
5.2 Starting / Stopping Requirements.
off the
gun body.
with a Size 17 mm
wrench.
off.
carefully
off the gun body.
- and replace same
if damaged.
with a Size
11 mm from the gun front attachment.
(re-
place if damaged) and the counter bush
from the threaded socket.
from
its seat - use a strong wire with one end
bent to form a small hook.
13