Device Installation - C2G 81642 Benutzerhandbuch

D I
RIVER NSTALLATION
Step 1
Turn off your computer and remove the cover/panel to expose the
PCI slot.
Step 2
Plug the 2‐Port USB 3.0 Card into the PCI slot on the computer.
Step 3
Replace the cover/panel and turn on your computer.
When your computer starts up, a Found New Hardware Wizard will
appear.
Note: The following setup is an example shown using a Windows
XP
operating system. Some screenshots may vary slightly depending
on
your operating system. The setup wizard is designed to step you
through each part of the driver installation process successfully.
Steps 4-7 will have to be completed two times because there
are
two USB 3.0 ports that need to be installed and recognized.
Step 4
When the Found New Hardware
Wizard appears, select Yes, this
time only, and click Next.
Step 5
Choose Install the software
automatically and click Next.
The Windows security pop‐up may
appear during this process. Click
Continue Anyway to continue with
the installation.
Step 6
Click Finish to complete the
installation and exit the wizard.
Step 7
The Found New Hardware Wizard will appear again. Repeat steps 4‐6
for second USB 3.0 port installation.