General Information; Introduction; Important Safety Instructions - MAXA 2600 W STD Benutzer- Und Installationsanleitung

1.GENERAL INFORMATION

1.1 INTRODUCTION

PLEASE NOTE. Do not dispose of any packaging until the installation of the air conditioner is completed. After
having removed the packing, check that all the content is intact and complete. (See list of accessories). In the event
of missing parts, contact your retENGLISHailer.
This air conditioner has been designed to cool or heat the air of a room and should only be used for this purpose.
The manufacturer cannot be held liable for damage caused to property or injury to persons or animals due to incorr
ect installation, regulation and maintenance or improper use. This air conditioner contains R410A refrigerant: at the
end of its life, the disposal of this air conditioner must be in accordance with the strict regulation governing the
recycling of this product, please operate with caution during the disposal. P lease contact your local authority for
regulatory advice. Do not switch on before having totally assembled the air conditioner and before installing in its
correct operating position. Before starting the appliance, check that it is correctly earthed, according to the
legislation in force in the country concerned.

IMPORTANT SAFETY INSTRUCTIONS

1.2
When using electrical appliances, basic safety precautions should always be followed:
Do not place objects on the product or allow objects to obstruct the inlet or outlet openings.
Extreme care should be taken when any product is used by, or near children and pets, and whenever the product is
left operating and unattended. Please note:
Before operating the product remove the air conditioner from its packaging and check it is in good condition.
Do not let children play with the packaging, for example plastic bags.
Do not operate any product with a damaged cord or plug, or after the air conditioner malfunctions, has been dropped,
or damaged in any manner. Return the air conditioner to an authorised service center for examination and repair to
avoid a hazard.
Do not attempt to repair or adjust any electrical or mechanical functions on this air conditioner as this may void
warranty, contact your service engineer.
Always operate the product from a power source of the same voltage, frequency and rating as indicated on the
product identification plate.
This air conditioner is not intended for use in wet or damp locations.
Do not place the air conditioner near an open flame, cooking or heating appliance, or hot surface.
Do not let the power cord hang over the edge of a table or counter. A rrange the power cord away from an area
where it may be tripped over.
Never place the power cord under a carpet or rug. Do not operate the air conditioner in areas where petrol, paint, or
other flammable liquids are used or stored.
Do not carry out any cleaning or maintenance or access internal parts until the air conditioner has been
disconnected from the mains electricity supply.
Do not alter the safety or regulating devices without the permission and ins tructions of the air conditioner
manufacturer.
Do not pull, remove or twist the electric cable connected to the air conditioner, even if disconnected from the mains
electricity supply.
Avoid prolonged direct contact with the flow of the air from the air conditioner and the room being closed with no
ventilation for a long period of time.
Repair or maintenance work must be carried out by a service engineer or by qualified technicians in compliance with
the instructions given in this booklet. Do not alter the appliance, since hazardous situations could be created while
the manufacturer of the appliance will not be liable for any damage or injury caused.
This instruction booklet is an integral part of the appliance and should therefore be carefully preserved and always
accompany the appliance in the event of transfer to another owner or user or another installation engineer.
Should the booklet be damaged or lost, please request an additional.
15