Intended Use - Hilti DCH 300 Handbuch

3.2 Product overview
DCH 300–X
3.3

Intended use

DCH 300
The product described is an electric cutter designed to be used with diamond cutting discs for dry-
cutting mineral materials.product.
DCH 300–X
The product described is an electric cutter designed to be used with diamond cutting discs for cutting
mineral materials with or without use of water.
When dry-cutting mineral materials, you must use a dust removal system complete with the appropriate filter
e.g. the Hilti VC 300–17 X universal industrial vacuum cleaner.
Use a vacuum cleaner with anti-static suction hose to avoid electrostatic effects.
Optionally, the product can also be used with synthetic resin-bonded abrasive cutting discs for metal-cutting
without water. Special accessories (80 mm diameter flange assembly, consisting of clamping flange and
reversible flange) are required for this application.
Use the product in push mode only (cutting disc count-rotating).
Operate the product only when it is connected to a power source providing a voltage and frequency in
compliance with the information stated on the type identification plate.
3.4 Possible misuse
Do not use the product in environments where there is a risk of explosion.
Do not use the product for roughing down or grinding.
Do not use the product to work on hazardous or flammable materials (e.g. asbestos, magnesium, wood).
24 English
Printed: 08.02.2018 | Doc-Nr: PUB / 5398318 / 000 / 01
2
Cut indicator
@
Dust removal connector cap
;
Guard
=
Water regulating valve
%
Water connection
&
Rear grip
(
Switch-on interlock release button
)
On/off switch
+
Service indicator
§
Portable residual current device (PRCD)
/
Diamond cutting disc
:
Front grip
∙
Guide roller
$
Arbor lockbutton
£
Hood clamping screw
|
Depth gauge
¡
Cutting depth indicator slider
Q
Clamping nut wrench, 24 / 10 mm AF
W
Hex key, 6 mm AF
E
2149874
*2149874*