Bryton Amis S430 Schnellstartanleitung Seite 12

Installing the Heart Rate Monitor
1 2
4
Note:
• Adjust the sensor position to the middle part of the body. The belt should be
worn under the chest and directly on your body. The Bryton logo shown on the
sensor should be facing upward. Tighten the elastic belt firmly so that it will not
turn loose during the exercise.
• In cold weather, wear appropriate clothing to keep the heart rate belt warm.
• If the sensor cannot be detected or the reading is abnormal, please wet the
electrodes area with water as shown in the step 3 or warm up the heart rate
sensor for about 5 minutes.
• If the heart rate belt is not used for a period of time, remove the sensor from the
heart rate belt to prevent the battery from running flat.
• Heart rate sensor does not work under water. This is common to all ANT+
sensors.
• For triathlon, it is recommended to wear Heart rate belt after swimming as water
will reduce the strength of heart beat signal. If the heart rate belt is wore before
swimming, heart rate data may not be properly recorded after leaving the water
for a period of time.
• The Amis devices and heart rate monitor (HRM) are waterproof. However, the
wireless signal does not transmit through water and as a result, this disrupts the
data communication between the device and the HRM.
11
3
5
Sensors
Heart Rate
Sensors
Heart Rate
Amis S430/S630 Quick Start Guide