Short Description; Operating Instructions; Control Panel With Thermostat; Switching On - Truma Ultraheat Gebrauchsanweisung

Short description

Truma Ultraheat is an additional 230 V electric heater for the
LPG heater models Trumatic S 3002 (P), Trumatic S 5002
and Truma S 55 T.
Heater operation is basically possible with gas only, electricity
only or simultaneously with electricity and gas.
When using simultaneously the electrical unit will switch itself
off before overheating occurs as a result of the stronger gas
burner.
When using electrical only we recommend to set the fan
control on position 3 (manual or auto), remembering to set the
output level to 2000 W (ensure that the fuse protection for the
power supply of the camp site is sufficient).
If more than 2000 W are required (heating up / cold tempera-
tures) you must refer back using gas operation as the 230 V
electrical operation is a secondary heater only.
The heater operation is regardless of the operating mode (gas
oder electricity) also possible without the Trumavent fan.
To ensure an even and rapid warm air distribution as well as
lower surface temperatures on the heating unit, we do rec-
ommend that you always operate the heater with a running
Trumavent warm air system.
If your Ultraheat is fitted with a remote sensor (accessory), do
not position it near any heat source (oven, lights, opposite of
blown air outlets etc.) or near a confined area where heat can
accumulate (under a shelf, near corners, behind curtains).
6

Operating instructions

Always observe the operating instructions and "Im-
portant operating notes" prior to starting! The vehicle
owner is responsible for correct operation of the appliance.

Control panel with thermostat

c
230 V ~
a = Rotary switch "Off"
b = Rotary switch "On" power settings:
500 – 1000 – 2000 W
c = Rotary control knob for room temperature
(illuminated by green indicator lamp "operation")

Switching on

Before switching on, ensure that the fuse protection for
the power supply of the camp site is sufficient for the
selected power setting (b – see "Technical Data").
Important: The electric feed line for the caravan must be fully
unwound from the cable drum.
To switch on, turn the rotary switch to the desired output
level (b).
Set rotary control knob (c) to the desired room temperature.
The thermostat setting on the control panel (1 – 9) must be
determined individually depending on the heating requirement
and the type of vehicle.
For an average room temperature of about 23 °C, we recom-
mend a thermostat setting of about 6 – 8.

Switching off

Switch the heating system off at the rotary switch (a).
Ultraheat
b
2000
a
b
500
b
1000