Machine Information - SKF TKSA 11 Bedienungsanleitung

3.6 Machine information

a. Distances
Tap the machine image and enter the three machine
dimensions as shown.
Tap on the measurement to select and specify new distance
measurements using the scroll wheel. The distances entered
from the previous alignment will be the default.
Since the distance between the sensors is ixed only three
distances must be speciied.
1. Measure and enter the distance between the centre
of the coupling and the centre of the rods on the
movable side.
2. Measure and enter the distance between the rods of
the movable side and the front feet (centre of foot).
3. Measure and enter the distance between the front
and back feet (centre of feet).
SKF TKSA 11 17