Brick; Installing Sanding Belts; Attaching Polishing Tools; Switching On And Off / Adjusting The Speed - Parkside PFBS 160 A1 Bedienungs- Und Sicherheitshinweise

First slide the tool you wish to use through the
clamping nut before inserting it into the
6
collet , fitting the tool shaft.
7 26
Press and hold the spindle lock
Insert the collet ,
7
then tighten the clamping nut
combination wrench
Using a tool with clamping mandrel:
Use the screwdriver end of the combination
wrench to loosen and tighten the screw on
25
the clamping mandrels.
Insert the clamping mandrel in the tool as de-
scribed.
Using the combination wrench
screw on the clamping mandrel.
Insert the attachment you wish to use onto the
screw between two washers.
Use the combination wrench
screw on the clamping mandrel.

Brick

Do not resharpen any edges by hand with
the brick .
21

Installing sanding belts

Slide the grinding belt
drel from the top. Tighten the screw on the grind-
24
ing mandrel to secure the grinding belt
24

Attaching polishing tools

Turn the polishing attachment
of the mandrel for polishing attachments
Switching on and off /
Adjusting the speed
Switching on / adjusting the speed:
Set the ON / OFF switch
pressing down and sliding it forward.
.
9
into the threaded insert,
26
using the
6
on the thread.
25
, loosen the
25
to tighten the
25
onto the grinding man-
23
23
on the point
22
32
to position „I" by
1
Set the variable speed control
between „1" and „MAX".
Switching off:
Set the ON / OFF switch

Using the grip collar with LED light

Hold the spindle lock
clamping nut
ter-clockwise.
Release the spindle lock
Then screw the union nut
the thread.
Screw the grip collar with LED light
thread, turning clockwise.
Hold the spindle lock
ing nut onto the thread, turning clockwise.
6
Release the spindle lock
Set the ON / OFF switch of the LED light
position "I" to switch it on (see Fig. C).
Set the ON / OFF switch of the LED light
position "0" to switch it off again.
Repeat the steps in reverse order to reattach the
union nut
5
Information about processing
materials / tool / speed range
Use the router bits to process wood, plastic and
sheetrock at maximum speed.
. Determine the speed range for processing zinc,
zinc alloys, aluminium, copper and lead by
testing scrap pieces.
Process plastics and materials with a low melt-
ing point at a low speed.
Process wood at high speeds.
. Clean, polish and buff at a medium speed.
Note: The milling bit
steel or iron. Suitable milling bits are available.
The following information are non-binding recom-
mendations. When performing the actual work also
test yourself, which tools and settings are ideal for
the material you are working on.
to a position
11
to position „0".
1
and unscrew the
9
from the thread, turning coun-
6
.
9
anti-clockwise from
5
8
and screw the clamp-
9
.
9
.
is not intended for use on
31
Start-up
onto the
to
36
to
36
GB 13