Using the accessories (see Ill. D)
Air mattress adapter
Use a pipe wrench to unscrew the nozzle
the air blow gun
Then – depending on what is needed – screw
on the air mattress adapter
dle
, as well as the thread adapter
12
the barrel of the air blow gun
Universal valve connection
Screw the universal valve connection
onto the compressed air hose
Cleaning and care
Thoroughly clean the spray stylus
ately after use. Otherwise the paint can dry and
cause problems during the next use.
Thoroughly rinse out the spray stylus
water.
Use the thinner included to clean any stubborn
dried paint.
Note: The thinner is not suitable for water-so-
luble paints. Rather, it corresponds to a varnish
for thinning paints containing solvents.
Note: If you remove the paint nozzle of the
air blow gun
9
threads before reattaching it so its freedom of
movement is not affected.
Never lay the entire air blow gun
vent bath.
Note: If the air intake of the compressor should
become dirty, use a dry cloth to remove the ac-
cumulated dirt.
Fault
Cause
1. Paint almost
empty
2. Paint too viscous 2. Lower viscosity
3. Dry / defective
nozzle
73868_par_Airbrush_Set_Content_FI-SE-DK.indd 11
, ball needle
6
12
9 a
.
9
or the ball nee-
6
into
7
.
9
10
directly
10
.
8
immedi-
3
with
3
during cleaning, lubricate the
in a sol-
9
Interrupted paint jet
or intermittent paint
delivery
Solution
1. Fill paint
3. Screw in nozzle tightly
or replace
Preparations for use / Cleaning and care
Fault
of
Cause
4. Paint supply
restricted
5. Incorrect posi-
tion of spray
stylus
.
3
Fault
Cause
1. Air head
dirty / defective
2. Nozzle dirty /
defective
Fault
Cause
1. Defective nozzle 1. Replace nozzle. Contact
2. Paint too viscous 2. Lower viscosity
3. Insufficient
working pres-
sure
Fault
Cause
Nozzle dirty /
defective
Interrupted paint jet
or intermittent paint
delivery
Solution
4. Cleaning
5. Correct position angle
Spray pattern
incomplete
Solution
1. Clean / replace air head
1. Rinse with clear water
2. Clean / replace air
nozzle
Spray pattern irregu-
lar with drips
Solution
a respective service centre.
3. Increase working pres-
sure (if necessary, not in-
cluded accessories, e.g.
pressure reducer)
3. Hose defective; replace
hose
Non-uniform paint
amount delivered
Solution
Clean / replace air nozzle
GB/IE
06.07.12 12:36
11