Connections, Operating And Display Elements Mix102Ag3 - LD Systems LDMIX102AG3 Bedienunganleitung

CONNECTIONS, OPERATING AND DISPLAY ELEMENTS MIX102AG3

14
5
6
7
8
3 4
2
1
1
MIC INPUT CH1–CH3
Balanced microphone input (XLR/6.3 mm jack combo). The use of an unbalanced microphone cable (mono jack) is also possible. Switchable
48 V phantom power (switch no 2).
2
PHANTOM ON/OFF CH1–3
Switchable 48 V phantom power for the microphone inputs (XLR) of channels 1 to 3 (CH1–CH3) for the use of condenser microphones
without independent power supply. Phantom power is on in the ON position and off in the OFF position. Ensure that the microphone channel
volume is set to minimum and that a microphone has been connected before switching on phantom power, and ensure that phantom power
has been switched off before disconnecting the microphone.
3
HI-Z CH1
This button switches the jack input of channel 1's combo jack (CH1) to high impedance (push down to activate). Channel 1 can now be used
as an instrument channel, e.g. for an electro-acoustic guitar.
4
10 dB CH1–CH3
Button to boost the signal level of the corresponding channel by 10 dB (push down to activate).
5
DFX CH1–CH3
Effect send control for channels 1 to 3 (CH1–CH3). The signal from the corresponding channel is sent to the internal effects processor (DSP)
after the volume control (post-fader) at a level corresponding to the setting of the effect send control. It is important to ensure that the
internal input of the effects processor is not overloaded (check PEAK LED).
6
HIGH CH1–CH3
High-frequency equalizer (12 kHz) for input channels 1–3 (CH1–CH3). Turn anti-clockwise to reduce treble and clockwise to increase treble.
The equalizer is inactive in the centre detent position.
17
15
16
5
5
6
6
7 7
8 10
8
4 4
1 1
18
13
19
20
12 28
11
9 27
26
25
23
22
30 21
29 24
5