Control Board - EuroLite 4x50W LED COB 3200K Bedienungsanleitung

Control Board

The Control Board offers several features: you can simply set the starting address or the brightness.
Browse through the main menu by pressing MODE. You can browse through the selection menu by pressing
ENTER. You can change the selection by pressing UP or DOWN. You can leave every mode by pressing
MODE. The functions provided are described in the following sections.
Setting DMX channel mode:
DMX MODE
ADDR:001-512 CH: 07/06/04/02/01
Dimming:
DIMMER
C1(4):oo F:00
Auto Mode:
auto run
fqn: 01 -99
99) can be selected via the UP or DOWN buttons.
Slave Mode:
Dimmer curves (8 types):
The device has 5 DMX channel modes. Press the MODE
button until the display shows DMX MODE. Press the
ENTER button twice. You can select the DMX channel mode
CH07, CH06, CH04, CH02 or CH01 via the UP or DOWN
button.
Press the MODE button until the display shows DIMMER.
Press the ENTER button to select brightness and flash
settings, respectively. You can select the desired brightness
(C1[4]00-99) - C1 LED1 and C2
speed (F00-99) via the UP or DOWN buttons.
In Auto Mode, the chasers are called up automatically in a
continuous loop.
Press the MODE button to select the Auto mode (AUTO
RUN). Press the ENTER button.
The desired frequency of the loops (Frequency = FQN 01-
Press the MODE button to select the SLAVE MODE. The
devices set in this manner can now be controlled by the
master unit (s. chapter Master/Slave-operation).
Press the MODE button until the display shows DIMMER.
Press the ENTER button. You can select the dimmer
CURVE: 01-08 via the UP or DOWN buttons (s.
illustration).
23/28
LED2 ... - or Flash
00071186.DOC, Version 1.0