After Ironing - Braun CareStyle 7 Bedienungsanleitung

(D) Iron Auto-Off
• When the iron is in the auto-off mode, the icon
is flashing and the temperature control LED (12) is
off. The iron will turn off to reduce power
consumption.
• It is activated if after 10 minutes there has been
no steam emission.
• To turn the iron on again, the On/Off button (2)
has to be pressed. Before starting ironing again
wait until the temperature control LED (12) is
continuously on.

After ironing

• Press the On/Off button (2) to turn off the
appliance.
• Unplug and let the appliance cool down before
storing.
• Empty the water tank.
• Lock the iron.
(E) Lock system
The lock system can be used for a safe and easy
storage of the steam station and the iron. Do not lift
or carry the appliance on the handle of the locked
iron.
• Place the soleplate into the recess on the iron
mat.
• Press down the tip of the iron until you hear a
"click" and the iron will be locked automatically.
• To unlock the iron slide the locking system
forward. The iron will be released.
(F) Descaling
To maintain optimum performance, the system
needs to be decalcified after every 15 litres of water
consumption (about 8 complete refills).
The icon is flashing.
• First, switch off and unplug the appliance.
• Unlock the iron and remove the iron from the iron
rest. Wait until the appliance has cooled down
(minimum 2.5 hours).
• Remove and empty the water tank.
• Remove the transparent cover (8) and unscrew
the cleaning valve (9).
• Empty the boiler.
• Pour in 500 ml tap water. Do not use any
chemicals, additives or descaler.
• Screw the cleaning valve (9) to close the boiler.
• Shake the base unit to rinse, then empty the
boiler.
• Repeat this procedure one more time.
DLB245628_5712811801_Use_Instruction_IS_7043_7044_7055_7056_INT.indb 11
• After having finished the descaling procedure,
plug in, switch on (2) and press the calc clean
system button (4) for 2 seconds to reset.
If the appliance is switched off without descaling,
the icon will start to flash again when it is next
switched on.
Note: Because of the different water composition
by using an installed in-house permanent descaler,
it is recommended to descale the system after every
4 complete refills. Please note that in this case the
icon for descaling will not automatically start
flashing.
(G) Cleaning and maintenance
• Before cleaning, always make sure that the
appliance is switched off, unplugged and has
cooled down completely.
• Wipe the soleplate clean with a damp or dry cloth.
• Never use scouring pads, vinegar or other
chemicals.
• To clean the soft material on the handle use a
damp cloth.
11
31.03.16 11:23