Replacing The Fuse; Technical Specifications - Omnitronic PAM-500 Bedienungsanleitung

7.1 Replacing the fuse

If the fine-wire fuse of the device fuses, only replace the fuse by a fuse of same type and rating.
Before replacing the fuse, unplug mains lead.
Procedure:
Step 1: Open the fuseholder on the rearpanel with a fitting screwdriver.
Step 2: Remove the old fuse from the fuseholder.
Step 3: Install the new fuse in the fuseholder.
Step 4: Replace the fuseholder in the housing.
7.2 Loudspeakers
If the speaker-system distorts, one of the loudspeakers may be defective. Test the speaker-system once
more with another amplifier. If the sound remains distorted, the speaker-system should not be operated any
more in order to prevent further damage. Please contact your dealer.
If clacking sounds are heard from the speaker-system, screws may have loosended due to the continuous
vibrations. The speaker-system should be checked by a specialist. Especially for public use, the speaker-
system should be checked before every operation so that the speaker-system and the speakers in the
systems are always well fixed.
Should you need any spare parts, please use genuine parts.
If the power supply cable of this device becomes damaged, it has to be replaced by a special power supply
cable available at your dealer.
Should you have further questions, please contact your dealer.

8. TECHNICAL SPECIFICATIONS

General:
Power supply:
Power consumption (max.):
Dimensions (H x W x D):
Weight:
Control unit:
Inputs:
4 mono
2 stereo
1 Aux-Return
Footswitch
Outputs:
2 Main Mix Out
1 Aux-Send
Rec Out
Amplifier:
Nominal power output:
Maximum power output:
Distortion:
S/N-ratio:
Frequency range:
Please note: Every information is subject to change without prior notice. 18.05.2005 ©
115/230 V AC, 50/60 Hz ~
150 W
760 x 845 x 330 mm
30 kg
XLR or balanced ¼" jacks
RCA or ¼" jacks
balanced ¼" jack
¼" jack
balanced ¼" jacks
balanced ¼" jack
RCA
60 W RMS / 4 Ohms
120 W / 4 Ohms
0.05 %
>80 dB
20 Hz - 20 kHz; +/- 1 dB
35/35 11038890_V_1_0.DOC