Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
18 Use the kettle only with the stand supplied (and vice versa).
19 Don't use the appliance if it's damaged or malfunctions.
20 If the cable is damaged, it must be replaced by the manufacturer, its service agent, or
someone similarly qualified, in order to avoid hazard.
touch controls
• You don't need to press the buttons hard – a light touch is enough.
• In some cases, it may detect your finger before it actually touches the button.
sleep mode
• If the appliance is inactive, and you don't touch the controls for 5 minutes, the lights will go
out, to save electricity.
• To wake the appliance, touch any button.
before using for the first time
Fill to max, boil, discard the water, then rinse. Do this three times, to remove manufacturing
dust, etc.
positioning
1 Put the stand on a stable, level surface. Route the cable so it doesn't overhang, and can't be
caught or tripped over.
2 Wind excess cable beneath the stand
filling
caution
keep clear, steam may escape from the lid.
3 Remove the kettle from the stand.
4 Press the lid release button to open the lid.
5 Fill with at least 2 cups of water, but not above max.
6 If you overfill, the kettle may spit boiling water.
7 Close the lid, and press down to lock it.
8 Check the lid is closed, or the kettle won't switch off when it boils.
switching on
9 Plug the stand into the wall socket.
10 Put the kettle on the stand – take care not to spill.
11 The buttons will flash twice, then glow steadily.
variable temperature
12 Touch the button marked with the temperature you want.
13 The temperatures available are: 100 (boil), 95 (coffee), 90, 80, 70, and 60 (that's °C).
14 The button will flash.
15 The kettle will start to heat up.
pulsing element
16 Initially, you'll hear the element pulse on, off, and on again, as it works to control the
temperature accurately.
17 When it reaches the set temperature, the button will stop flashing and glow steadily.
18 After 5 minutes, the light will go out, and the appliance will go to sleep.
changing temperature
19 If you get the temperature wrong, and want to change it:
a) touch the correct button
b) the button will flash while the water heats or cools
c) when it reaches the set temperature, the button will stop flashing and glow steadily
, Reducing the temperature may take a long time – you may prefer to pour the hot water away,
and refill with cold water.
household use only
91
Werbung
Inhaltsverzeichnis
