Care And Maintenance; Troubleshooting Guide - Cocraft DPL 124B Bedienungsanleitung

Information
• The screwdriver has two forward-pointing LEDs (8) which function as work
lights. The LED lights come on automatically when the trigger is pulled and
go off 5–10 seconds after the trigger is released.
• The screwdriver has an automatic spindle lock, which allows you to
use it as a manual screwdriver if the battery has been discharged or
the screwdriver is too underpowered to complete the job.
• The spindle lock is activated as soon as you begin screwing
the screwdriver manually. The maximum torque is 10 Nm.
• Do not overload the spindle lock.
• Do not pull the trigger when the spindle lock is on.

Care and maintenance

• Clean the product using a lightly moistened cloth. Use only mild cleaning
agents, never solvents or corrosive chemicals.
• If the screwdriver is not to be used for a long time, the battery should be
fully charged before the tool is stored away.
• Store the screwdriver in a dry place out of children's reach whenever it is
not to be used for a long time.

Troubleshooting guide

The screw- •
driver doesn't •
start.
•
The screwdriver •
stops or is •
sluggish.
•
•
The battery •
does not •
charge. •
•
The battery is discharged. Charge the battery.
The overload or overheating protection has been
triggered. Let the screw driver rest and cool for a few
seconds before resuming work.
Faulty power trigger. Contact our customer services.
The battery is discharged. Charge the battery.
The overload or overheating protection has been
triggered. Let the screwdriver rest and cool for a few
seconds before resuming work.
If the problem persists, make sure that the screw-
driver is not overloaded. Reduce the load.
Is the task suitable for the screwdriver?
Is the charger properly connected to the wall socket?
Check that the wall socket is live.
Is the battery correctly connected to the charger?
Is the battery defective or too hot/cold?
10