• Select the desired channel by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the calibration value.
• Adjust the desired calibration value between –128 and 127 by pressing [UP] or [DOWN].
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 3
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] or [DOWN] to select "TIME".
- Fixture running time
With this function you can display the running time of the device.
• Select "MATI" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the number of hours.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Lamp running time
With this function you can display the running time of the lamp.
• Select "LATI" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows"XXXX", "X" stands for the number of hours.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Clear lamp time
• With this function you can clear the running time of the lamp. Please clear the lamp time every time you
replace the lamp.
• Select "CLLT" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows "ON" or "OFF".
• Press [UP] or [DOWN] to select "ON" if you wish to enable this function or "OFF" if you don't.
• Press [MODE/ENTER] to confirm.
• Press [EXIT] in order to return to the main menu.
- Main menu 4
• Press [MODE/ENTER] to enter the main menu (display flashing).
• Press [UP] to select "EDIT".
- Define the number of steps in Run
With this function you can define the number of steps in the Program Run.
• Select "STEP" by pressing [UP] or [DOWN].
• Press [MODE/ENTER], the display shows"S-XX", "X" stands for the total amount of steps you want to
save, so you can call up to 48 scenes in "RUN". For example if the "XX" is 05, it means that "RUN" will run
the first 5 scenes you saved in "EDIT".
• Press [MODE/ENTER] to save and exit.
41/84
00026543.DOC, Versiom 1.5