KKT KOLBE GS60ED Benutzerhandbuch Seite 80

Installation
Before using the dishwasher
Before using the device for the first time, check the following:
• Whether the dishwasher is mounted in one level and on the
base;
• Whether the tap is fully open;
• Whether there are no leaks at one end of the supply or drain
hose;
• Whether the supply and drain hose are properly tightened;
• Whether the supply and discharge hose are not kinked;
• Whether the power supply is switched on;
• Whether the water softener was filled with 1 liter of water and
salt;
• Whether the dosing unit of the rinse aid has been refilled.
Important informations and final notes
If your device does not work properly, you should turn it off
!
from the power source; Then please contact our customer
service at www.kolbe.de.
→ Do not try to repair the device yourself!
The device must be accessible so that the technician can carry out the
required repair. If no good access to the device is ensured, the technician
will not perform the repair.
If the customer insists on the repair, he must give the technician his
written consent to the repair and in this case the customer is responsible
for any damage caused by the device installed contrary to this manual.
This also applies to situations in which appliances are clad in wall tiles,
sealed with sealing material or in front with wooden obstructions, e.g. are
sheathed with a base. Furthermore, in the case that another installation
was performed as listed in the specification of the company KKT KOLBE.
IMPORTANT: The manufacturer reserves the right to make minor changes
to the instructions resulting from the innovations or technological chan-
ges of the device which have no influence on the function of the device.
80