Supplied Items; Interconnections - Sony SDT-D11000 Benutzerhandbuch

Part 2. Preparation

Supplied Items

Interconnections

After you confirm that you have all of the required accessories for your
installation, connect the drive to the host computer, and select the SCSI ID
with the rotary switch on the rear panel.
When you first open the box, make sure it contains the following items.
Contact your supplier if anything is missing or broken.
• DDS Drive Unit
• Power Cable
• Operator's Guide
SDT-D11000
The SCSI bus allows connection of up to fifteen peripherals to the host
computer. Use a SCSI cable with a 68 pin connector.
Precautions
• Switch off the host computer and peripherals before connecting the SCSI
cable.
• Make sure the SCSI connectors are pressed tightly together.
• If this unit is the last (or only) device on the SCSI bus, make sure to connect
a SCSI bus terminator to the open connector.
• The total length of the SCSI cable(s) between the host computer and the last
device should be less than 3 meters.
• To set up the LVD configuration, you need:
1) Host PC with the LVD SCSI Board, 2) only LVD devices on the SCSI
bus, and 3) LVD/SE switchable terminator.
AC power
*1
When using high-speed data transfer with the SDT-D11000, it is recommended that total
length of the SCSI cable not exceed 1.5 m (SE) or 12 m (LVD).
*1
Figure 2-1. Interconnections
11
Part 2. Preparation