Ironing Without Steam - Siemens slider SL45 Gebrauchsanleitung

C
Ironing with steam
The steam control is used to adjust the amount
of steam produced when ironing.
By default, the steam station automatically chooses
the "i-Temp" steam setting.
The steam setting can be changed by the user by
changing the temperature. The steam station will
propose the suitable steam level automatically.
Temperature icon
on display
If necessary, the steam level can be adapted to your
needs by touching the
The selected icon flashes until the pressure
corresponding to each steam level is reached.
Steam is now ready to be released by pressing the
steam release buttons (13 or 14*).
attention:
• When ironing on a lower temperature setting
only press the steam release button (13) for a few
seconds at a time.
If you find that water is dripping out of the
soleplate, set the temperature to a higher position
(take care that the garment can be ironed on
this heat temperature setting).
• At the beginning of each use, it is possible that
drops of water will be dispensed alongside steam.
Therefore, it is advisable to try the iron on the
ironing board or a piece of cloth to start with.
Tip : for better ironing results, iron the last strokes
without steam to dry the garment.
"pulseSteam"
function
This appliance has a special function for tackling
difficult creases. The "pulseSteam" function helps
soften stubborn garments like jeans or a linen
tablecloth faster.
When the steam release button is activated, the
steam generator will release three powerful shots of
steam so that the steam reaches even deeper into
the fabrics.
1. Set the temperature to the
2. Press the steam release button (14*) on the top
of the handle.
Steam setting
icon on the display (8).
setting.
or (model dependent)
Quickly press the steam release button (13) on the
bottom of the handle twice (double-click)
remarks:
• It is possible to stop the shots of steam by quickly
pressing the steam button again.
• Some water drops may appear when you use the
"pulseSteam" function for the first time. The water
drops will disappear after you have used the
function for some time.

Ironing without steam

This enables the iron to be used for dry ironing.
Begin ironing but without pressing the steam release
buttons (13-14*).
D
vertical steam
This can be used to remove creases from
hanging clothes, curtains etc.
It cannot be used on a synthetic setting for
delicate items.
Warning!:
• Never direct the steam jet at garments that are
,
being worn.
• Never aim the steam at people or animals.
1. Set the temperature to the
2. Hold the iron in an upright position setting 15 cm
away from the garment being steamed.
3. You can steam iron curtains and hanging
garments (jackets, suits, coats...) by placing the
iron in a vertical position and pressing the steam
release button (13 or 14*).
"Intelligent steam"
function
(model dependent)
This system has intelligent steam control, which,
after releasing the steam release button, provides a
small amount of additional steam.
The additional steam can always be stopped by
briefly pressing the steam release button once again.
setting.
19
SIEM ENS