Connecting The Subsystem; Setting The Scsi Id - Sony SMO-S551 Bedienungsanleitung

Connecting the Subsystem

You can hook up a maximum of seven SCSI
peripheral devices to a single host computer
through its SCSI bus.
Notes
• Before connecting the subsystem, be sure to
turn off the subsystem and all other devices on
the SCSI chain.
SCSI cable
(sold separately)
to another
SCSI device

Setting the SCSI ID

The factory default setting for the SCSI ID is "0."
If necessary, this ID number can be changed
using the SCSI ID switch on the rear panel. Be
sure to turn off the power before making any
changes.
Pushing the "+" button raises the ID number;
pushing the "–" button lowers the ID number.
SMO-S551 Magneto-Optical Disk Subsystem
A B C D E F G H
1
SCSI ID
0
SCSI CONNECTOR
to SCSI connector
SCSI cable
(sold separately)
to the host computer or
another SCSI device
• If the disk unit is the last device on the SCSI
chain, set the function switch F on the rear
panel to "1" to turn on the internal terminator.
When it is not the last device, make sure that the
terminator is off (function switch F is set to
"0").
• The total length of the SCSI cables connected to
a SCSI chain must not exceed six meters (19
feet 8 1/4 inches).
AC IN
F.GND
to AC IN
connector
AC power cord
(supplied)
to an AC outlet
Notes
• The subsystem will not operate properly unless
the SCSI ID has been set correctly.
• Make sure to select a SCSI ID that has not been
assigned to another SCSI device.
Chapter 2 Getting Started
23