Filling The Pressure Sprayer Tank; Building Up The Operating Pressure; Spraying - FLORABEST Z30597 Bedienungsanleitung

©
Filling the pressure
sprayer tank (Fig. E)
Note: Before using the product, check to
see that it is in good condition and free of
defects.
Press the pump handle
and turn it anticlockwise.
Note: Before you open the tank, pull
the safety valve
3
any residual pressure still present in the
container .
5
Draw the pump
2
.
5
Now fill the tank. Ensure that the use of
the pesticide, liquid fertiliser or cleaning
agent is permitted in your country and
that it is compatible with your pressure
sprayer.
Note: Fill the tank with only the
amount of liquid that you actually need
for that particular spraying session (not
more than 5 l).
Place the pump
2
tainer and turn the pump handle
5
clockwise as far as it will go.
©
Building up the operating
pressure (Fig. F)
Fold out the two footplates
Before you start pumping, place your
feet on the footplates
the pressure sprayer is held in a stable
position during the pumping process.
Move the pump handle
until the pressure sprayer has been
pumped up to a pressure not exceeding
the maximum permissible operating
pressure of 2.5 bar. To ensure this value
®
downwards
1
upwards to release
out of the container
©
back into the con-
1
.
7
to ensure that
7
up and down
1
Bringing into use
is not exceeded, monitor the pressure
gauge during the pumping process.
4
Note: If the pressure of the air in the
container exceeds 2.5 bar, the pres-
5
sure is automatically released through
the safety valve .
3
Press the pump handle
into the recesses.
Turn the pump handle
1
far as it will go. This secures the handle.
Now take the spray tube
holder.
Fold in the two footplates
Spraying (Fig. G)
Hang the pressure sprayer over your
shoulder by the carrying strap
Note: Ensure that the pressure sprayer
is always kept upright. Only when held
in this orientation will the sprayer work
properly.
Hold the spray tube firmly by the han-
dle and direct the adjustable spray
17
nozzle e.g. at a plant.
11
Set the adjustable spray nozzle
provide the desired spray cone. To create
a broad spray cone, turn the front part
of the adjustable spray nozzle
wise. To create a concentrated jet, turn
the front part of the adjustable spray
nozzle anticlockwise.
11
Press the trigger to start the spraying
19
process.
Release the trigger to stop the
19
spraying process.
Note: When the pressure in the con-
tainer is no longer sufficient to spray,
5
pump the container
5
pressure again up to but not exceeding
the maximum permissible operating
downwards
1
clockwise as
out of the
12
.
7
.
6
to
11
clock-
11
to increase the
GB/IE 11