How-To" Maintenance; Periodic Operation And Inspection - Dolmar GE-1100 Bedienungsanleitung

8. "HOW-TO" MAINTENANCE

(See Fig. 5 5 )
Make sure the engine is stopped before
starting any maintenance, servicing or
repair.
NOTE
It is recommended to use ear protection
when performing operation, maintenance
and repair of the generator set.
GB
GB
1. ENGINE OIL CHANGE (See Fig. 5 5 -q q )
GB
Change engine oil every 50 hours.
■ ■
GB
(For new engine, change oil after 20 hours.)
GB
(a) Drain oil by removing the drain plug and the oil
GB
filler cap while the engine is warm.
q OIL DRAIN PLUG
GB
(b) Reinstall the drain plug and fill the engine with oil
GB
until it reaches the upper level on the oil filler cap.
GB
Use fresh and high quality lubricating oil to the
■ ■
GB
specified level as directed on page 6.
If contaminated or deteriorated oil is used or the
GB
quantity of the engine oil is not sufficient, the
GB
engine damage will result and its life will be
GB
greatly shortened.
GB
2. SERVICING THE AIR CLEANER
GB
(See Fig. 5 5 -w w )
GB
Maintaining an air cleaner in proper condition is
very important.
Dirt induced through improperly installed,
improperly serviced or inadequate elements
damages and wears out engines. Keep the
element always clean.
(a) Unhook the cover and remove the cleaner element.
q ELEMENT
w AIR CLEANER COVER
(b) Paper element: Clean by tapping gently to
remove dirt and blow off dust. Never use oil.
Clean paper element every 50 hours of
operation, and replace element every 200 hours
or once a year.
(c) Urethane form : Wash the element with fresh
water. Squeeze out the water then dry the
element. (Do not twist.)
12
CAUTION
3. CLEANING AND ADJUSTING
SPARK PLUG (See Fig. 5 5 -e e ,r r )
q SPARK PLUG
w PLUG WRENCH
(a) If the plug is contaminated with carbon, remove
it using a plug cleaner or wire brush.
(b) Adjust the electrode gap to 0.6 to 0.7 mm
Spark plug :
4. CHECKING CARBON BRUSH
(See Fig. 5 5 -t t )
If the brush become excessively worn, its contact
pressure with the slip ring changes and causes a
roughened surface on the slip ring, resulting in
irregular generator performance.
Check the brush every 500 hours or if generator
performance is irregular.
If the brush is 5 mm long or less, replace it with a
new one.
q BRUSH HOLDER
w BRUSH
e 5 mm
r M5 BOLT : 1 pc.
(a) Disconnect the wire connector and remove the
brush.
(b) Carefully note the brush direction and relative
position with the slip ring when installing new
brush.
9. PERIODIC OPERATION AND
INSPECTION
When furnishing the generator as emergency
electric power source, periodic operation and
inspection are needed.
Fuel (gasoline) and engine oil will be deteriorated
with time, and this causes that the engine is
difficult to start and as the results improper
engine operation and fault.
CAUTION
Since the fuel (gasoline) will be deteriorated
with time, replace fuel (gasoline) with fresh
one periodically; once every three (3)
months is recommended.
BMR4A (NGK)