Sprintis DBM3100 Bedienungsanleitung Seite 9

Operation
Before punching
1. Get the documents ready in order.
2. Decide the desired margin size (see chart 1).
3. Adjust the margin width adjuster on right side of machine to the desired margin size
(2 mm / 3 mm / 4 mm / 5 mm).
4. Set the paper stop guide to the appropriate paper size. 34 holes in front of paper entrance
were marked (see chart 2).
5. There are pull-push pins in machine, when some corresponding places are no need to be
punched holes, please pull out relevant pull-push pins (see chart 3).
6. Use a testing paper to check the holes and margin right or not before formal punching.
Punching
1. Place the ready document fl at on base of machine aligning it against the paper stop guide and
sliding it horizontally into the punching entrance.
Follow up the below chart to set the max. punch sheets:
Document type
Max. punching sheets
2. While holding the documents into place, slowly pull the punching handle down towards the
document.
3. Push handle upwards back to its initial position and remove the punched document out and
keep the documents in order.
Chart 1
Chart 3
Paper 80 g PVC fi lm 0.175 mm
15
Cardboard < 2 mm
5
Chart 2
1
9