Placing The Batteries - Velleman CAMD13 Bedienungsanleitung

5. Overview
Refer to the illustrations on page 2 of this manual.
Bullet Camera
1 base
cover
2
Dome Camera
base
1
IR LED
2
6. Operation
6.1

Placing the Batteries

Bullet Camera
Slide the cover towards
1.
the front of the bullet
camera and open the
battery compartment.
Place 2 x AAA batteries
2.
(not included) minding the
polarity.
Slide the cover onto the
3.
housing to close the
battery compartment.
The bullet camera is now
4.
ready to be installed (see
Installation below).
Dome Camera
Open the battery compartment on the underside of the dome camera.
1.
Place 3 x AA batteries (not included) minding the polarity.
2.
Close the battery compartment.
3.
6.2 Installation
Choose your installation spot. You may install the camera in a visible spot and in such way as to
1.
cause a dissuasive effect.
Use the base as a template. Mark the position of the screw holes with a pencil.
2.
3. Drill the necessary holes using an appropriate electric drill (not included).
Place a nylon plug in each of the holes.
4.
Bullet Camera
Fix the bullet camera using the included screws.
5.
Dome Camera
Fix the base of the dome camera using the included screws. Remember to leave the screws a few
5.
millimetres out in order to hold the camera.
Slide the dome camera onto the screws and twist it in a clockwise direction to fix.
6.
V. 01 – 22/06/2015
CAMD13
3 lens
IR LEDs
4
lens
3
4 ©Velleman nv