Crivit Z32130A Bedienungsanleitung Seite 10

When the alarm is switched on, at the set time an alarm signal will buzz
for 30 seconds.
Note: Press the SELECT button 2 , the SET button 3 or the LIGHT button 4
to stop the alarm signal. Otherwise it will buzz for another four times at
intervals of 2 minutes.
If the hourly alarm is switched on, there will be a beep tone every full hour.
1. Press the SELECT button 2 in time mode until the display „ALARM"
2. Press the SET button 3 to select between the alarm signals A1 to A5.
3. Hold the SET button pressed down to proceed to the setting of the
4. Press the SET button again to make the alarm settings.
5. Press thee MODE button 1 to save the settings.
10
34232_LCD-Sportuhr_content_IE_FI_DK.indd 10
e) Hourly alarm (alarm every clock hour) (A5)
Set the alarm as shown below:
appears.
selected alarm.
To do this, follow Steps 1 to 6:
GB/IE
05.03.14 17:04