Fault Elimination By The User; Fault Elimination By The Qualified Installer; Guarantee; Environment And Recycling - AEG MTD 350 Gebrauchs- Und Montageanweisung

for the user and the qualified installer
3.

Fault elimination by the user

Fault
No hot water despite fully opened hot
water fitting.
Table 3
4.

Fault elimination by the qualified installer

Fault
Flow too weak
Heating fails to switch on / no hot
water.
Table 4
5.

Guarantee

For guarantees please refer to the pespective terms and conditions of supply for your country.
The installation, electrical connection and first operation of this appliance should be carried out by a
qualified installer.
The company does not accept liability for failure of any goods supplied which accor-dance with the
manufacturer's instructions.
5.1

Environment and recycling

Please help us to protect the environment by disposing of the packaging in accordance with thenational
regulations for waste processing.
14
272867-34655-0751 MTD 350 - 570.14 14
Cause
No electrical power.
The turn on flow rate needed to switch on the
heating power has not been reached. Soiling or
furring of the jet regulator.
Cause
Jet regulator furred or soiled.
Filter soiled.
No electrical power.
Heating system defective.
The pressure limiter has released
Remedy
Check the fuses in the house installation.
Clean or if necessary renew the jet regulator
(see „2.11 Special accessories").
Remedy
Clean or if necessary renew the fitting jet regu-
lator (see „2.11 Special accessories").
Clean the filter in the cold water inlet A (2)
after shutting off the water supply.
Check the fuse (house installation).
Measure heating system resistance, if necessary
exchange the unit.
Determine and eliminate the cause for the fault.
Disconnect from power and relieve the pressure.
Reactivate pressure limiter E (a).
30.01.2008 16:19:51