Wahl 8267 Originalbetriebsanleitung Seite 5

f Only use accessories recommended by the manufacturer.
f Never insert or allow objects to fall into the openings of the
appliance.
f Do not carry the appliance by the mains cable and, when
disconnecting the appliance from the mains, always pull
the plug rather than the cable or the appliance.
f Do not wind the mains cable around the appliance.
f Keep the mains cable and appliance away from hot
surfaces.
f Make sure that the mains cable is not twisted or kinked
when stored.
General user information
Information about using the operating manual
f Consider the operating manual as part of the product
and store it in a safe and accessible place.
f This operating manual is also available in PDF for-
mat from our service centre. The EC declaration of
conformity can also be requested in other official EU
languages from our service centre.
f Include this operating manual if passing the appliance
on to a third party.
f In the case of conflicts with national safety specifica-
tions or instructions, the national requirements must
be followed.
Explanation of symbols and notes
DANGER
Danger of electric shock which may result in
serious physical injury or death.
WARNING
Warning of possible physical injury or a health
risk.
CAUTION
Information about danger of material
damage.
Note with useful information and tips.
Action to be taken by owner.
f
Carry out these actions in the sequence
1., 2., 3.
described.
Product description
Description of parts (Fig. 1)
A Blade set
B Cutting length adjustment lever
C On/off switch
D Hanging loop
E Mains cable
F Adjusting screw
G Blade guard
H Oil for blade set
I Cleaning brush
Not shown Attachment combs and various accesso-
ries (depending on model). See packaging for more
accessories and attachment combs.
Technical data
Cutting length: 0.4 – 3.5 mm (depending on the model)
Drive unit: quiet oscillating armature motor
Emission sound pressure level: max. 60 dB(A) @ 25 cm
Vibration: < 2.5 m/s2
Operating conditions
Ambient temperature: 0°C – +40°C
Technical data for different models: see page
84.
Start-up
f Check that the contents are complete (see
packaging).
f Check all the parts for possible transport damage.
f Oil the blade set (Fig. 6).
Checking/adjusting the blade amplitude
The blade amplitude is set at the optimum setting
ex-factory. However, the blade amplitude can change
as a result of voltage fluctuations. For lower voltage
the blade amplitude can be smaller and for higher
voltage bigger. If necessary, by changing the setting
of the adjusting screw (F), you can adjust the blade
amplitude yourself. Use a screw driver to do this.
1. Using the on/off switch, switch on the appliance
(Fig. 2ⓐ).
2. Turn the adjusting screw (F in a clockwise direction
until you hear a loud noise (Fig. 3ⓑ).
3. Then turn the adjusting screw anti-clockwise until
the loud noise stops (Fig. 3ⓐ).
Operation
Cutting length adjustment (all models except 8167)
Raise the adjustment lever – minimum cutting
·
length (Fig. 4ⓐ)
Lower the adjustment lever – maximum cutting
·
length (Fig. 4ⓑ)
Cutting with attachment combs (depending on model)
The appliance can also be operated with attachment
combs. Attachment combs can be used to extend
the cutting length range. Depending on the model,
en
5