Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Commissioning
Method A:
1. Connect the receiver to a 230V AC socket, the device will emit a signal tone
and is ready to be coupled for about 30 seconds.
2. Press the button on the transmitter within this time to couple the two devices.
A successful coupling is confirmed by another signal tone.
3. The doorbell is now ready for use.
Method B:
1. Connect the receiver to a 230V AC socket, the device will emit a signal tone
and is ready to be coupled for about 30 seconds. Should these 30 seconds
elapse without a coupling, just press the (L) button on the front of the receiver.
Another signal tone will confirn the successful coupling.
2. The doorbell is now ready for use.
Melody selection
A total of 16 different melodies are available. Everytime you press the „M" but-
ton on the front of the receiver, the melody will be changed to the next pre-in-
stalled ringtone. The sound will be applied automatically if you do not press the
button again.
Removing the coupling
1. Press the (L) button on the front of the receiver for about 6 seconds until ano-
ther singal sounds.
2. If you now push the bell button, the receiver no longer plays any sounds.
Set up transmitter
Please pay attention to power lines, gas and water pipes during installation.
NOTE: The installation of the transmitter to a metal surface (e.g. door frame made
of metal) can reduce the transmission power.
1. Drill holes in the wall and insert the dowels.
2. Carefully open the cover with a screwdriver by pushing the retaining collar inside.
3. Supply the back of the cover with the sealing rings included in delivery, before
you mount the cover at the frontage.
4. Insert the battery. Pay attention to the correct polarity and a centered placing
of the battery.
5. Close the cover by clipping the round side first and locking the angled side
with the retaining collar afterwards. Make sure that the seal is placed correctly.
NOTE: If the frontage is very coarse-grainded we recommend an additional sea-
ling of the back (e.g. with acrylic). Thereby you can prevent that water enters the
case at the backside.
8
Werbung
Inhaltsverzeichnis
