Programmable Functions; Selecting The Memory - ModelCraft MC-6 Bedienungsanleitung

c) Programmable functions
Attention!
Some setup values, e.g. the control/correction of the pitch values - must not be performed in ready to fly
state, e.g. because the engine would start up inevitably when actuating the pitch function on the
transmitter. Acute danger of damage to persons and/or assets!
To safely perform these settings without unnecessary programming, we recommend detaching the
three plug-type connections motor/motor speed adjuster. To do so, you should code the respective
contacting pairs with different colours beforehand to relocate them after performing a control/correction
and thus achieve the correct rotation direction of the engine.
In the following, we will describe the programmable functions in the sequence in which they are called up on the
remote control by pressing the mode button. Please read the entire chapter carefully before programming your remote
control!
Your remote control is designed for the two most common swash plate controls. Also observe the notices in the
chapter "Swash plate setting" further down in this operating manual. You can select the following controls:
„1-S": The swash plate is tilted via one roll and pitch servo each. The pitch control is performed by a separate servo.
„3-S": Symmetric three-point control of the swash plate via three control points offset by 120° each connected to a
pitch servo (front or rear) and two roll servos (on the left and right side). For pitch control, all three servos move
the swash plate axial at the same time.
Attention!
All settings, mixers and functions are only performed correctly if the adjustment elements (servos,
gyros, etc.) are plugged into the receiver in a certain sequence.
Slot Receiver Function
CH 1 Swash disk
CH 2 Swash plate
CH 3 Engine
CH 4 Yaw*
CH 5 Aux**
CH 6 Swash plate
* Here you can connect the tail servo or a gyro
** Switching channel for special functions or when using a gyro to switch the sensitivity

Selecting the memory

The currently selected memory slot number blinks.
Use the +/- rocker (ill. 3, pos. 4) to switch between memory slots 1 to 6. All
subsequent settings relate to the selected memory slot.
52
1-S 3-S
Roll Roll right
Pitch Pitch
Engine Engine
Yaw* Yaw*
Aux** Aux**
Pitch Roll left
Illustration 11