Palram Skylight Shed Montageanleitung Seite 3

A
IMPORTANT
Please read
these instructions carefully before you start to assemble this shed.
Please carry
out the
steps
in
the order set
out
in
these instructions.
Keep these
instructions
in
a
safe place
for future
reference.
Tools &
Equipment
Tool
-
(supplied)
Safety
This shed
must
be placed and fixed on
a
leveled surface to ensure its
stability.
Make sure
that screws and anchors are compatible with surface type.
RSome parts have metal edges.
Please be
careful when handling components.
RAlways
wear gloves, eye
protection, and long sleeves when assembling or
performing any maintenance on your
shed.
Do
not attempt assembly
on days
with
strong winds or low temperatures. If using
a
stepladder or power tools ensure that you follow the manufacturer's safety advice.
RDo
not stand on the roof.
RDo
not store hot items such
as
recently used grills, blowtorches etc.
in
the shed.
RHeavy
or sharp articles should not
be
leaned against the wall panels.
RTo
prevent suffocation, do not allow children to play
with
packing materials.
RShed must be secured by
drilling through floor
panels holes locations and inserting
suitable
screws
into ground
Jefore you start
RConsult
your local
authorities for
any
building limitations
or permits required to
construct this garden
shed.
IRComplete site
preparation before unpacking parts and beginning assembly.
RIt
is
highly recommended to
be
assisted by
a
second person
in
some steps.
RSort
the parts and check against the contents parts list.
RPlease
take safety precautions during assembly.
During Assembly
When
encountering the information icon, please refer to the relevant
assembly step for additional comments and
assistance.
This
icon indicates
that the installer should
be
inside the product.
=
Attention:
ni
This
icon indicates that
the installer should be
outside the product.
Rt
It
is
important to drill the
screws at
the top of the
panel ridge and to
make sure
that
screws
penetrate through the
panel
in
order to
have
maximum durability.
4/ Make sure
to position the
panel's
bottom ridge towards the
shed
floor
and that it
is
enclosing
it.
Step 3: Place the first wall panel at the back
of
the shed,
according to the stamped
serial
number
(Part 7699).
Step 33:
Please
apply silicone (caulk) sealant at the connection between both
Aluminum
profiles (diagram
d), in
order to prevent water from seeping
in.
Step 44: Note that
panels and profiles connected
in
the right direction
as
well
as
the profiles holes placed correctly
as
illustrated.
Step 46:
Push
aluminum profile against part #8439 and then
use
Self-Drilling
screws
(4045#) to connect to the profile (Diagram
B). No pre holes
is
needed.
Step 52: Anchor the shed on to
a
solid surface such
as
concrete or asphalt,
use
suitable
screws
and plugs.
(Screws and plugs are
not supplied).
*Please
note: Anchoring this product to the ground
is
essential to
its
stability
and
rigidity. It
is
required to complete this stage
in
order for your warranty to
be
valid.
Do
not tighten
screws and nuts
(411
& 412)
until completion of assembly process.
These
2
icons indicate if screws'tightening
is
required or not.
A El
I
riii
.4
-1