Feeding In Continuous Mode; Set Volume - Nestle Health Science Compat ella Gebrauchsanweisung

EN
46

8. Feeding in Continuous Mode

Continuous mode is used to deliver tube feed at defined rates, with or without a volume limit.
Step Button
1
2"
2
3
4
2"
5
6
Function Instruction
The most recent nutritional therapy settings are always saved in memory. When pow-
Turn the pump on er is turned on, the display shows the last programmed flow rate and volume and the
actual volume given.
Load the administration set in the pump
Review the volume given
Press
this therapy
Clear the volume given If desired, press
this therapy Note:
• Hold 2 seconds (2") to activate auto-prime. The pump will fill the administration set
Prime the administration with a predetermined volume.
set • P ress again to stop priming at any time.
Note:
Press
tube feed delivery.
Set the rate
• T he rate may be set from 1-600 mL/hr in 1 mL/hr increments.
Note:
Press
amount of tube feed to be delivered.
• Feeding with a dose limit: The value may be set from 1-4000 mL in 1 mL increments.
Set the volume
• Continuous feeding without volume limit: Set the value to CONT (Continuous), the
pump will run continuously until the nutrition container is empty.
Note:
and review the
VOLUME GIVEN THIS THERAPY
to clear the
VOLUME GIVEN THIS THERAPY
This should always be done when starting a new nutritional therapy.
Do not prime when connected to the patient's feeding tube.
to access the screen and use
SET RATE
Press to reset value.
to scroll to the

SET VOLUME

Press to reset value.
.
.
and to define the rate of
screen and use and to define the
EN