Dremel 3D40 Original Bedienungsanleitung Seite 21

PREPARING BUILD PLATFORM
DO NOT DROP THE BUILD
WARNING
!
PLATFORM. TEMPERED GLASS
PLATE MAY BREAK AND RESULT IN PERSONAL
INJURY.
DO NOT REMOVE TEMPERED
WARNING
!
GLASS PLATE FROM PLASTIC
HOLDER. CONTACT WITH TEMPERED GLASS PLATE
EDGE MAY RESULT IN PERSONAL INJURY.
BEFORE EVERY BUILD MAKE
WARNING
!
SURE THAT THE BUILD
PLATFORM IS COVERED WITH DREMEL SPECIFIED
BUILD TAPE. USE OF IMPROPER BUILD TAPE MAY
RESULT IN EQUIPMENT DAMAGE AND POOR
OBJECT BUILD QUALITY.
1. If build platform is installed, remove by pinching the
clip located at the front of the build platform and
lifting the build platform off the base, figure 3.
2. Remove adhesive liner from Build Tape and place
Build Tape over Build Platform. For best results,
apply Build Tape at center of Build Platform first
and smooth outward to remove any air bubbles,
figure 4.
3. Install the build platform using the build platform
clips.
FIG. 3
LIFT
PRESS
Build Platform
21
FIG. 4
Build Tape