Britton Fika Gebrauchsanweisung Seite 5

FITTING THE TRAY LEGS AND FOOTREST
Locate the two front upper legs. Ensure that these are legs that have pre-drilled holes.
(Fig. 2.1)
Line up the screw in the leg and the hole in the seat frame and turn the leg clockwise until it is
firm. Ensure that the pre-drilled holes are facing the front.
Do not over-tighten. Repeat with opposite side.
Locating the pre-drilled holes in the front upper leg, line up the footrest with the holes. (Fig. 2.2)
Insert supplied bolts and tighten with phillips head screwdriver (not supplied). (Fig. 2.3)
Do not over-tighten the bolts. Repeat with opposite side.
FITTING OTHER LEGS
Locate the two rear upper legs.
Line up the screw in the leg and the hole in the seat frame and turn the leg clockwise until it is
firm. (Fig. 3.1)
Do not over-tighten. Repeat with opposite side.
The chair should look like as shown in Fig. 3.2.
Locate the four bottom legs.
Line up the screw and the hole and turn clockwise until the leg is firm. (Fig. 3.3)
Do not over-tighten. Repeat with opposite side.
Rotate the stoppers located at the end of the bottom legs. (Fig. 3.4)
Ensure the stoppers are rotated to sit firmly to the surface before use of the chair.
ATTACHING AND ADJUSTING THE TRAY
Note: The plastic tray can be adjusted and has three positions.
To attach the tray, align this with the arm rests, pull lever underneath the front of the tray while
sliding tray along armrest to desired position. Release the lever. (Fig. 4.1)
The tray features a sub-tray which is easily removed by locating the lip and lifting up. (Fig. 4.2)
To remove the tray pull lever towards you whilst holding the chair firmly with the other hand and
slide forward. (Fig. 4.3)
HARNESS
The safety harness is provided to restrain your child and should always be worn.
To secure child in harness, push buckle (a) into the buckle housing (c) until the buckle prongs
snap into the position. (Fig. 5)
Carefully adjust the harness by pulling the slider (d) until the desired fit is achieved in the lap,
shoulder and crotch strap.
To release the buckle squeeze the top and bottom prongs until it disengages.
CONVERTING HIGH CHAIR TO LOW SEAT MODE
The high chair can also be converted into a low chair by inserting the four bottom legs directly
into the seat by turning clockwise until the legs are firm.
Do not over-tighten.
Importer: Speli Baltic Ltd, Estonia. Tel. +372 6700623; info@brittonbaby.com
EN EN
5