Task 3: Connecting To The Network; Task 4: Connecting The Power; Task 5: Installing The Software - Promise Technology SMARTSTOR NS4600 Kurzanleitung

SmartStor NS4600 Quick Start Guide
4. Insert the screws through the holes in the drive carrier and into the sides of
the disk drive.
• Install only the counter-sink screws supplied with the SmartStor.
• Install four screws per drive.
• Snug each screw. Be careful not to over-tighten.
5. Reinstall the drive carrier into the SmartStor enclosure.
Repeat steps 2 through 5 until all of your disk drives are installed.
6. Close the door on the front of the SmartStor.

Task 3: Connecting to the Network

To connect the SmartStor to your network:
1. Attach one end of the network cable to the RJ45 network connection.
See Figure 2.
2. Attach the other end of the network cable to your Ethernet hub or switch.

Task 4: Connecting the Power

To power the SmartStor:
1. Attach the power cord on the back of the SmartStor enclosure and plug the
other end into the power source. See Figure 2.
2. On the back of the SmartStor, press the power button. See Figure 2.
It takes about a minute to boot the SmartStor. When fully booted:
• The System Status LED turns blue. See Figure 1.
• The buzzer beeps one time.

Task 5: Installing the Software

The SmartNAVI software connects your PC to the SmartStor, sets up the
SmartStor, sets up network drives on your PC, performs backups and other
management functions.
6