Introduction & Features - Velleman CS150 Bedienungsanleitung

1. Introduction & Features
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm
the environment.
Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a specialised
company for recycling.
This device should be returned to your distributor or to a local recycling service.
Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
With your CS150, you can hunt for coins, relics, jewellery, gold and silver just about
anywhere. The Discriminator Metal Detector is versatile and easy to use.
The detector's features include:
Earphone Jack - lets you connect earphones (not supplied) to the detector.
Vu-meter – indicates the probable type of metal being detected.
3-Tone Audio Discriminator - sounds distinctive tones for different types of metals, to make
target identification easier.
Adjustable Stem - lets you adjust the detector's length for comfortable use.
Waterproof Search Coil - lets you use the search coil even if you must put it under water.
Note: The search coil is waterproof, but the control housing is not waterproof.
Note: Your metal detector requires three 9V-batteries (not supplied).
2. Treasure Hunter's Code of Ethics
All treasure hunters might be judged by the example you set. Here are a few basic rules you should follow:
• Always get permission before searching any site.
• Respect the rights and property of others.
• Observe all national, state, and local laws while treasure hunting.
• Never destroy historical or archaeological treasures. If you are not sure about an object you have found, contact
a museum or historical society in your area.
• Leave the land and vegetation as it was. Fill in any holes you dig.
• Use your detector only in safe areas.
• Dispose of any junk you find, only in approved areas. Do not leave it for the next treasure hunter to find.
3. Preparation
a. Assembling the Metal Detector
Assembling your detector is easy and requires no special tools. Just follow
these steps.
1. Turn the stem's lock nut clockwise until it loosens.
2. Lengthen or shorten the stem so when you stand upright with the detector
in your hand, the search coil is level with the ground and about 1/2 to 2
inches (1 to 5cm) above it with your arm relaxed at your side.
CS150
CS150 – METAL DETECTOR
- 3 -
VELLEMAN