HQ Power VDPC130 Bedienungsanleitung Seite 8

• Copying a Program
o Press and hold the PROGRAM button (11) to enter the programming mode.
o Select the desired bank using the BANK buttons (15 and 16).
o Press the MIDI / REC button (19) to prepare for copying.
o Select the target bank using the BANK buttons (15 and 16).
o Press the MUSIC / BANK COPY button (12) to copy the bank. All LEDs on the panel will flash.
c. The Chaser
A chaser is a sequence of different banks that will be called up one after another. With this VDPC130, you can
program up to 6 different chasers, each chaser up to 240 scenes.
• Programming a Chaser
o Press and hold the PROGRAM button (11) to enter the programming mode.
o Select the desired chaser using the CHASER selection buttons (22).
o Select the desired program using the BANK buttons (15 and 16).
o Select the desired scene using the SCENE selection buttons (3).
o Press the MIDI / REC button (19).
o Program the next step until the chaser is finished or the maximum number of scenes (240) has been reached.
o Press and hold the PROGRAM button (11) to save the chaser.
• Running a Chaser
o Press the respective CHASER buttons (22) and press the AUTO / DEL (21). Adjust the chaser speed by
pressing the TAP button (17) twice. The time interval between two presses determines the speed (up to 10
minutes).
o Press the MIDI / REC button (19) and select the desired record using the SCANNER selection buttons (1).
• Checking a Chaser
o Press and hold the PROGRAM button (11) and select the desired chaser using the CHASER buttons (22).
o Press the DISPLAY button to switch the display to step mode. Check every scene individually by pressing the
respective BANK button (15 and 16).
• Editing a Chaser
o Copying a Bank into a Chaser
Press and hold the PROGRAM button (11) to enter the programming mode.
Select the desired chaser using the CHASER buttons (22). The respective LEDs will be lit.
Select the bank to be copied using the BANK buttons (15 and 16).
Press the MUSIC / BANK COPY button (12) to prepare for copying.
Press the MIDI / REC button (19) to copy the bank. All LEDs on the panel will flash.
o Copying a Scene into a Chaser
Press and hold the PROGRAM button (11) to enter the programming mode.
Select the desired chaser using the CHASER buttons (22). The respective LEDs will be lit.
Select the bank in which the scene will be copied using the BANK buttons (15 and 16).
Select the scene you want to copy using the SCENE buttons (3).
Press the MIDI / REC button (19) to copy the scene. All LEDs on the panel will flash.
VDPC130 8 VELLEMAN