Operation - SEVERIN AH 7908 Gebrauchsanweisung

Operation

∙ Remove the vacuum cleaner from its wall
bracket.
∙ If required, fi t any of the nozzle
attachments provided to the suction
aperture.
∙ Switch on the appliance using the On/Off
switch.
∙ If the vacuuming power decreases during
operation, the appliance will automatically
switch off to prevent the battery from
being over-discharged. Recharge the
battery if this occurs. Always ensure that
the appliance is switched off before
putting it in the charging station.
Crevice tool
The crevice tool can be inserted into the
suction aperture to clean crevices, corners
and other areas diffi cult to reach.
Crevice brush
The crevice brush can be fi tted to the crevice
tool and is suitable for cleaning uneven
surfaces such as computer keyboards etc.
Cleaning
General
∙ Before cleaning the appliance, remove
the vacuum cleaner from the wall bracket.
∙ To avoid the risk of electric shock, the
appliance and the adapter must not be
immersed in liquid or allowed to come into
any contact with liquid.
∙ If necessary, the housing may be wiped
with a damp cloth. Wipe dry afterwards.
To empty the dust container
Reduced vacuuming power despite a fully
charged battery pack indicates that the dust
container and fi lter inlay must be emptied.
10
∙ Hold the vacuum cleaner in your hand
∙ Push the release button, open the dust
container in a downward and forward
direction, remove the fi lter and empty it.
∙ The fi lter can be cleaned by slightly
tapping it or by using a brush.
Should the fi lter be visibly dirty, it should
be thoroughly cleaned with soapy water
(make sure to let it dry completely
afterwards) or replaced by a new one.
Only then may the vacuum cleaner be
used again.
Battery pack – replacement or disposal
∙ This appliance contains a nickel-metal
hydride (Ni-Mh) rechargeable battery
pack, which may be removed for
replacement or disposal. When replacing
the battery pack, ensure that only an
original battery pack is used.
∙ The battery compartment is located on
the underside of the appliance. Open the
compartment by removing the screw in
the compartment cover using a suitable
coin. Press the lower end of the locking
catch on the connectors. In that way, both
sides of the connection can be separated
by pulling them apart. When inserting a
new battery pack, push together the two
connectors and ensure that the catch
locks over the stop.
∙ Never dispose of old battery packs
in domestic garbage,
but only through the
proper public collection
points. This also applies
to the battery packs of
defective appliances.
Disposal
Devices marked with this symbol must