Alesis MultiMix 8 Bedienungsanleitung Seite 6

CONNECT THE MULTIMIX USB 2.0 TO THE COMPUTER
•
Connect your microphones and line-level sources to the MultiMix USB 2.0
•
Connect your output devices - headphones or speakers, or both - to the MultiMix USB 2.0. Turn their
volume down to zero
•
Turn on the MultiMix USB 2.0
•
Connect the USB 2.0 cable to both the MultiMix USB 2.0 and your computer
•
Turn your computer on
NOTE: If your computer "hangs" when following this procedure, turn off both the mixer and the computer. Try
turning on the computer first. Turn on the MultiMix USB 2.0 only after your computer has completely booted up.
START YOUR COMPUTER'S AUDIO RECORDING APPLICATION
•
Within the recording application, select the MultiMix USB 2.0 as the recording and playback device
•
Adjust the MultiMix USB 2.0's sample rate and buffer sizes as appropriate
• Assign
one or more MultiMix USB 2.0 inputs and begin recording
•
Raise or lower the trim knobs and volume sliders on the MultiMix USB 2.0 to achieve a strong signal
which does not distort (clip)
•
Use the equalizer to sculpt the sound
•
To record the signal along with the built-in effects or AUX bus effects, record the master fader signal.
Individual channel signals include EQ but do not include effects
•
On the MultiMix USB 2.0, assign the "2-TK" output from the computer to the monitor mix
•
Raise the monitoring level (headphones or monitor speakers) on the MultiMix USB 2.0 to listen back
See the Reference Manual for additional details.
Minimum PC Requirements:
•
•
•
•
•
Minimum Macintosh Requirements:
•
•
•
•
MINIMUM COMPUTER REQUIREMENTS
Pentium 4, 2.4GHz Processor (or equivalent, such as any Intel Centrino
notebook computer)
512 MB RAM
Available USB 2.0 Port
(2 tracks in and out at 44.1kHz/48kHz with USB 1.1 port)
Windows XP (with Service Pack 2 or higher installed) or Vista (32-bit)
5400 RPM or faster hard drive recommended for multitrack audio
G5 with native USB 2.0 support
(2 tracks in and out at 44.1kHz/48kHz with USB 1.1 port)
Mac OS X version 10.4 or later
512 MB RAM
5400 RPM or faster hard drive recommended for multitrack audio