C) Starting, Using, Closing Setup Mode - VOLTCRAFT SEM4500 Bedienungsanleitung

c) Starting, using, closing setup mode

• Setup mode can be started and ended by pressing the
3 seconds each time. The settings are applied when closing.
Important:
Setup mode can only be called when the energy cost meter is in the
"CURRENT" mode, see Chapter 8. a).
• If no indicator is flashing, you can also exit setup mode by briefly pressing the
button (2). Settings will be saved.
• If no indicator is flashing in setup mode, you can use the
switch to the period record (see Chapter 10. e).
• If no indicator is flashing in setup mode, you can use the
switch between the various setting functions.
The following settings are available:
- Time and 12/24 h mode
- Electricity tariff 1 and 2 (costs and start time)
- Setting the standby and low standby limit value
- CO emissions value of the electricity tariff
2
- Alarm in the event of overload
- Delete mode
• To change the setting of the function shown on the display, briefly press the
button (3).
• Change the flashing value with the
pressing the
depending on the setting function.
button (3) switches to the next input point or ends the input,
button (6) or
button (3) for
button (6) to
button (7) to
button (7). Briefly
51