Conrad 600 TVL Bedienungsanleitung Seite 3

O P E R A T I N G I N S T R U C T I O N S
CMOS Colour Camera Set, 600 TVL,
6 mm
Item no. 75 44 76
Intended use
This camera is intended for installation in, monitoring and protecting, secluded or critical areas
(e.g. entrance areas, surveillance of underground car parks and the like).
The product is designed for use indoors and outdoors (IP65).
The camera is only intended to be used with a stabilised direct current of 12 V/DC (using the
power adapter supplied).
Please bear in mind that it is prohibited by law to observe strangers with a camera without
their knowledge and consent. Observe the rules and regulations of the country where you are
using the camera.
The safety instructions must be observed at all times!
Any use other than that described above could lead to damage to this product and involves
the risk of short circuits, fi re, electric shock, etc. No part of the product may be modifi ed or
converted!
This product complies with the applicable national and European requirements. All names of
companies and products are the trademarks of the respective owners. All rights reserved.
Package Contents
• Colour camera with ceiling/wall holder
• Special cable for video signal and power supply (length approx. 20 m)
• Wall plug transformer
• Allen key
• Assembly material
• Operating Instructions
Safety Instructions
The warranty will be void in the event of damage caused by failure to observe
these safety instructions! We do not assume any liability for any resulting
damage!
We shall not accept liability for damage to property or personal injury caused
by incorrect handling or non-compliance with the safety instructions! In such
cases, the warranty will be null and void.
Dear customer,
these safety instructions are not only for the protection of the product but also for
your own safety and that of other people. Therefore, please read this chapter very
carefully before using the product for the fi rst time!
a) General
• The unauthorised conversion and/or modifi cation of the product is not permitted for
safety and approval reasons (CE). Do not open/disassemble! It does not contain
any internal parts that need to be adjusted or maintained by you.
• The product is not a toy and should be kept out of the reach of children. It should
be operated out of the reach of children.
• Make sure that the connection cables are not pinched or damaged by sharp
edges.
• If the camera is used with other devices (e.g. a monitor), the operating instructions
and safety notices for these devices must be followed.
• Do not leave packaging material carelessly lying around, since it could become a
dangerous plaything for children.
• In commercial institutions, the accident prevention regulations of the Employer's
Liability Insurance Association for Electrical Systems and Operating Facilities are
to be observed.
• In schools, educational centres, hobby and self-help workshops the operation of
the product is to be supervised by trained employees.
• Handle the product with care; it can be damaged by impacts, blows, or accidental
falls, even from a low height.
• If you have any questions that are not answered in these operating instructions,
please contact our technical support centre or consult a professional.
www.conrad.com
Version 12/12
• Safe operation can no longer be assumed if:
- the device is visibly damaged,
- the device no longer works
- the device has been stored under adverse conditions for a long time
- it was exposed to heavy loads during transport
b) Camera
• The camera is intended to be used only with a stabilised direct current of 12 V/DC
(e.g. using the power adapter supplied). The inner contact of the round plug should
be Plus/+, the outer contact Minus/-.
• The camera is suitable for use in indoor and outdoor areas (IP65). However, it
must never be used in or under water, as this will destroy it.
• The plugs on the camera's connection cable are not waterproof or watertight and,
therefore, must be placed in a dry indoor area.
• The use of the surveillance camera system does not replace the personal supervi-
sion of children or people who require special assistance, but serves only as a
support to this supervision.
• The camera should not be exposed to extreme temperatures, direct sunlight,
strong vibrations or heavy mechanical stress.
• Make sure that the connection cable is not pinched or damaged by sharp edges.
• Disconnect the power supply from the camera if it is not to be used for a while (e.g.
for storage).
c) Wall plug transformer
• The design of the wall plug transformer complies with Protection Class II. Use only
a standard mains socket as the voltage source (see section "Technical Data").
• The power adapter is intended for use only in dry indoor rooms; it must not get
damp or wet; never touch it with damp wet hands!
There is a risk of a life-threatening electric shock!
Protect the power adapter from direct solar radiation, strong heat and cold, dust and
dirt, vibrations or mechanical loads.
• When the product is taken from a cold to a warm room (e.g., during transport),
condensation may be produced.
Allow the product to reach room temperature before you connect it to the mains
voltage. This may take several hours. Otherwise, there is lethal danger due to an
electric shock!
• Do not pull the wall plug transformer from the mains socket by pulling on the cable.
• If the wall plug transformer is damaged, do not touch it; there is danger to life from
electric shock!
First switch off the mains voltage to all poles of the mains socket to which the wall
plug transformer is connected (e.g. switch off at the corresponding circuit breaker
or remove the safety fuse, then switch off at the RCD protective switch).
You can then unplug the wall plug transformer from the mains socket. Dispose of
the damaged wall plug transformer in an environmental-friendly way, do not use it
any more.
Replace it with a new wall plug transformer with the same specifi cations.