C) Deleting Registered Radio Remote Controls - KeyMatic KM300 Bedienungsanleitung

c) Deleting registered radio remote controls

• Press the lower key "Lock" for approx. 2 seconds.
• The first occupied memory slot, e.g. "1", will appear in the display The symbols
• Select the memory slot to be deleted, e.g. "3" with the "Lock" or "Unlock"
• To delete the selected memory slot, press the small button "Setup" on the door
• If the delete process has been successfully, the LC display will display "OK" and
60
If you press the key "Lock" again for a longer period (press the key for
about 2 seconds) the delete process will be terminated without a
memory slot being deleted (e.g. if you have pressed a key by mistake).
If no key on the door lock actuator is pressed for 3 minutes after the
menu has been retrieved, the menu is aborted automatically without
deleting a memory slot.
for radio reception and "Unlock" flash; this functions as notice of readiness that
the door lock actuator is ready to receive a memory slot.
buttons.
Please note:
Only occupied memory slots appear. If no radio remote control has
been registered, the LC display sends out an error message
("EMPTY").
lock actuator briefly.
terminate the menu with three short signal tones.
The door lock actuator can no longer be operated with the deleted radio
remote control.
If a lost or stolen radio remote control crops up again, it can of course
be registered again under point b) "register radio remote control on the
door lock actuator" and used as usual.
As it is not possible to copy the radio remote control, there is nothing
against continuing to use it quite normally!