Montage - Sonnenkönig TORONTO 14“ Bedienungsanleitung

8. Please check whether the power wire or plug is damaged or not, before using the
fan.If the power soft wire is damaged, for avoiding risk, it must be replaced by the
manufacturer, maintenance department or similar professional persons.

2. MONTAGE

EN
Installation of head and main body
Connect the patch plug of each Two-core cable (black
black) Respectively as Figure .
Insert the main body part into The socket of head. Lock
the Head and main body with two Screws at the
Installation of main body and chassis
Installation of mesh enclosure and blade
– Screw off the lock cap of the blade from the motor shaft.
– The angle of the assembled mesh enclosure is adjusted Suitable;
and then the mesh enclosure is sleeved aiming at.The three studs
of the front shell of the motor.
– The lock nut of the mesh enclosure is assembled and rotatesIn
clockwise to be tightened.
Installation of blade
– The blade is inserted into the motor axis; the slot at the back
Of the blade aims at the axis bolt; the blade is installed at the
Bottom so that the blade matches with the motor shaft.
– The lock cap of the fan is locked in the motor axis in clockwise,
And then the lock cap is fixed.
Installation of front mesh enclosure
– The hoop of the front net is fixed above the rear net.
– The hoop is buckled around the rear net; and the front and Rear
mesh enclosures match with each other.
– Finally, the fixing netting clip below the hoop is buckled.
40